Frequently Asked Questions About Pad Heaters From MDS
Q: What does a Pad Heater look like?
A: Pad Heaters are thin Flexible heating pads built to conform the outside surface of an engine oil sump or any metal fluid reservoir.
Q: How are Pad Heaters installed?
A: Pad Heaters are easily installed by following the step by step instructions and with basic shop tools. Everything needed for a complete installation is included with each heater.
Q: What is the warranty for a Pad Heater?
A: Pad Heaters have a 1 year warranty.
Q: How hot does the oil get?
A: Pad Heaters raise oil temperatures to approximate operating levels.
Q: Is a thermostat required?
A: No, when the heater is sized correctly, a thermostat is not required.
Q: Will Pad Heaters burn the oil like immersion type heaters?
A: Pad Heaters apply Heat to the oil through a very large surface area.
Because the temperature of that surface is far below the level that would
damage oil, the result is a gentle and even Heating.
Q: How long does it take a Pad Heater to do it\'s Heating job?
A: Pad Heaters will generally raise cold oil temperatures by 38°C (100°F) in 1.5 - 2 hours.
Full Heating is usually accomplished in 5-6 hours.
Q: How does a Pad Heaters do a better job of Heating the engine than block heaters or tank type heaters?
A: Pad Heaters put Heat into the oil supply. HEAT RISES to warm important INTERNAL components.
Q: Can a Pad Heaters be installed on a curved surface?
A: Yes, a Pad Heater can be installed on single plane curves as short as about 1\" radius.
They are not to be installed on a compound curve area.
Q: Can a Pad Heaters be installed on the side of a pan?
A: Pad Heaters do a better job installed at the bottom of the sump (HEAT RISES).
However, an installation of the side of a sump or reservoir will yield excellent results.
Q: Can Pad Heaters be used on diesel fuel tanks?
A: We recommend against an installation on a diesel fuel tank due to the possibility of overheating the fuel supply.
Q: Can Pad Heaters be used on transmissions?
A: Yes, Pad Heaters are suitable for all types transmissions.
Q: How do Pad Heaters compare in use of electricity with old style coolant heaters?
A: Pad Heaters , application for application, use less energy than block or tank type coolant heaters.
Pad Heaters are more economical to operate than block heaters. Compare watt ratings.
Q: Will a Pad Heater save me money?
A: YES, Pad Heaters will save you money by increasing engine and starter life. They are maintenance free and use much less electricity than a block heater.
Q: Should the use of any coolant heater presently in place be continued?
A: YES, the use of any block or tank type coolant heaters can be discontinued.
Q: How does Pad Heaters stand up in an environment of grease, oil, dirt and periodic engine cleanings?
A: Pad Heaters are constructed of materials resistant to the effects of oil, grease, dirt and water.
Direct blasts with the pressure washers used in engine cleaning should be avoided.
Q: Are there other available in other voltages?
A: Yes. There are heaters available in 220 volts and 12 volts D.C.
We have all sizes available!
NEW in stock the oversized 300mm x 500mm 1000 Watt pad for Hydraulic oil tanks. End of winter special for only ¤195.00 plus shipping and applicable taxes. Regular price ¤225.00. Discounts for bulk orders!
ponude
